PSU NCP3063 0.35 amp boost regulator

This board offers a 0.35 amp buck point-of-load switch-mode regulator.

N.B. THIS IS A Boost TOPOLOGY…..+Vin MUST ALWAYS BE LOWER THAN Vout

Features:

1. +3.5 to +18VDC input voltage range
2. Output adjustable from -1.25 to -15VDC
3. 150KHz switching freq.
4. 0.8 amp output capability (with adequate heatsinking)
5. Dimensions: approx. 38 x 18 x 16 mm (L x W x H).
6. Ideal for use with solderless breadboard mounting.
7. Is one of 3 options from us…Buck/ Boost/ Invert
8. Add-on output filter also available to suit lower noise requirements.
9. Shipped with snap-off pins unfitted…need soldering.
10. Made in England.

PINOUTS:-

P2                              P1

1 +Vout                      16 +Vout

2 0V                            15 0V

3 FB                            14 Ipk

4 0V                            13 SW

5 0V                            12 0V

6 0V                            11 0V

7 0V                            10 0V

8 +Vin                           9 +Vin

(the FB pin can be used to connect an external voltage feedback circuit)

Refer to the datasheet at http://onsemi.com  for explanations of other pin

Functions.

DO NOT FIT R1 IF VR1 IS FITTED.

OUTPUT VOLTAGES FOR TYPICAL R1 VALUES FOLLOW…

VOLTS OUT           R1 VALUE

+5V                          2K45

+9V                          5K06

+12V                        7K03

+15V                        9K

+24V                        14K87

( use nearest preferred value 0.1% resistor or compromise on accuracy)

INPUT VOLTAGE RANGE=3.5  to 18VDC nominal for this board.

OUTPUT VOLTAGE RANGE=1.25  to 15VDC